I’m not currently using Performances and have not tried Multi Mode (my needs haven’t required it up until now). The Impulse is able to send MSB and LSB data, but despite numerous attempts at programming knobs, I have not been able to get the S70 to recognize the commands. Ideally, I would like to be able to access all of the S70 banks and voices directly from the Impulse controls, with as few button pushes/encoder turns/slider adjustments as possible (for example, program one knob for banks and one knob for voices). But it seems as though that method is limited to the bank/category that is currently active on the S70 (as the values sent only range from 0 - 127). I’m aware that the Impulse supports Program Change messages, by using a variety of button pushes (Shift-MIDI) and data knob input. I’ve spent several days reading the manuals for both keyboards, reviewing the Yamaha data list, looking at videos, and searching the forums. I am not using a computer and would prefer not to. To that end, I’ve organized the voices for my live performance into a single bank (USR4). What I’m trying to do, for live performance, is to set up one or two control(s) on the Impulse (the fewer the better) to dynamically change the programs/voices on the S70. ![]() I also own a Novation Impulse MIDI controller. ![]() I’m grateful that this community is here and appreciate any advice that I can get. ![]() ![]() In fact, I’m new to electronic keyboards as well. I’m new to the forum and posting for the first time.
0 Comments
Leave a Reply. |